Taking a shower without water pressure or even using faucets in the same state are very uncomfortable situations. It is important to remember that, for safety reasons and to ensure good water pressure, qualified professionals must always install showers and faucets.
Several reasons may be causing the feeling of low water pressure in faucets and showers you can visit our website for plumbing service. Shall we see some?
What Can Cause Low Water Pressure?
In technical analysis, the problem is not about the pressure itself. What determines the pressure at the points of use is the height of the reservoir (water box). Therefore, tubes with different gauges have the same pressure. It is a mistake to think that there will be more pressure by increasing the gauge of the tube.
What determines the water flow is the gauge size (diameter) of the pipes. The larger the gauge, the greater the flow. A good professional will be able to correctly size the pipes of the installations so that low flow and pressure problems do not occur. Generally speaking, this part of the hydraulic design follows regulatory gauge size standards. Coldwater and hot water building systems – Design, execution, operation, and maintenance.
Low water flow can also happen for the following reasons:
– valves that are not open enough to vent faucets and showers;
– the faucet may be clogged with sediment and particles that are blocking the passage of water. To find out if that’s right, release the aerator from the faucet and clean the cartridge (cylindrical part). It is essential to check whether the faucet installed is low or high flow;
– Lack of water inside the pipes and consequently air bubbles that came from the water tank. Air bubbles act as a barrier to the passage of water to faucets, toilets, and showers. This problem is very common in areas where water shortages are frequent. It is also common to happen after periodic cleaning of the water tank.
Some Additional Tips
Locating a water leak may not be accessible when we are not sure where the problem arises. So, pay attention to your water meter. Turn off the water and see the reading you have at that moment; if you keep stirring, it is an indication that there is a water leak, and you should find it.
Never break the wall without being sure exactly where the problem is, as instead of solving the problem, you can make it worse.
If the leak is in the heater, professional repair is required; unless you have experience, do not try to solve the problem yourself. In this case, it is always better to call an expert in the field.
Before starting any repairs, make sure you have all the necessary tools. Remember that a professional plumber has technical resources to help you find the exact spot of a leak and provide the best repair solution or you can click here to get a plumbers help.
